Green Technology & Innovation 2979-1456 Caravel Press 10.36922/gti.8110 2025.002 Implementation of sustainable refrigeration technology with phase-change material storage at rural communities in Kampung Labang, Bintulu Sarawak, Malaysia: A case study https://orcid.org/0000-0003-0921-3283 JarimiHasila hasila.jarimi@ukm.edu.my https://orcid.org/0000-0002-6931-2163 ZhangYanan yanan.zhang1@nottingham.ac.uk MajidNik Aida Mastura Abdul nik5564@yahoo.com MohamedWan Mohamad Fadhli Wan h.jarimi@gmail.com MatusupKezie alisahsolar@gmail.com https://orcid.org/0000-0002-3911-0851 RiffatSaffa saffa.riffat@nottingham.ac.uk Solar Energy Research Institute, Universiti Kebangsaan Malaysia, 43600 Bangi, Selangor, Malaysia Department of Architecture and Built Environment, The University of Nottingham, University Park, Nottingham, United Kingdom School of Education, Universiti Kebangsaan Malaysia, Bangi, Selangor, Malaysia Sekolah Kebangsaan Labang, Bintulu, Sarawak, Malaysia 04042025 1 1 15 4 April 2025 © 2025 The Author(s). Published by Caravel Press. 2025 This is an open access article under the CC BY 4.0 licence.

Solar-powered refrigeration is a promising solution for ensuring sustainable access to cooling in areas with weak or off-grid electricity supply. However, conventional solar-powered fridges rely heavily on high-cost electrical battery storage and photovoltaic (PV) panels, which limit their economic feasibility in many rural settings. To address these challenges and reduce reliance on electrical storage, phase-change materials (PCMs) have been introduced as a viable thermal energy storage solution. A PCM system can be more energy-efficient than conventional solar-powered fridges because it stores excess cooling during the day and releases it during night-time or cloudy conditions. This leads to reduced dependence on electrical batteries, which are typically a major cost driver in solar refrigeration systems. Experimental validation demonstrated that PCM packs maintained an average temperature of 6.73°C in the chiller and −5°C in the freezer during low or zero solar irradiance, outperforming conventional solar-powered fridges with the same electrical battery and PV panel arrangement. The integration of PCM reduced the levelized cost of cooling to 27 cents USD/kWh, or 70% lower than conventional solar-powered fridges. In addition, this study uniquely combines technical advancements with social engagement by involving end-users through pre-installation analysis and semi-structured interviews, ensuring the system’s relevance, practicality, and acceptance. These findings highlight the importance of integrating both technical and social perspectives to accelerate the adoption and implementation of sustainable cooling technologies in off/weak-grid areas.

 Rural refrigeration Solar PV PCM storage Low-cost PCM Real case study International Institute of Refrigeration. The Carbon Footprint of the Cold Chain: 7th Informatory Note on Refrigeration and Food. France: International Institute of Refrigeration; 2021. doi: 10.18462/iir.INfood07.04.2021 10.18462/iir.INfood07.04.2021 Karoney EM, Molelekoa T, Bill M, Siyoum N, Korsten L. Global research network analysis of fresh produce postharvest technology: Innovative trends for loss reduction. Postharvest Biol Technol. 2024;208:112642. doi: 10.1016/j.postharvbio.2023.112642 10.1016/j.postharvbio.2023.112642 Amjad W, Munir A, Akram F, et al. Decentralized Solar- Powered Cooling Systems for Fresh Fruit and Vegetables to Reduce Post-Harvest Losses in Developing Regions: A Review. Oxford: Oxford University Press. doi: 10.1093/ce/zkad015 10.1093/ce/zkad015 Park CY, Kim K, Helble M, Roth S. Getting Ready for the COVID-19 Vaccine Rollout. Manila, Philippines: Asian Development Bank; 2021. doi: 10.22617/BRF210071-2 10.22617/BRF210071-2 Riffat J, Kutlu C, Brito ET, Su Y, Riffat S. Performance analysis of a PV powered variable speed dc fridge integrated with PCM for weak/off-grid setting areas. Fut Cities Environ. 2021;7:6. doi: 10.5334/fce.121 10.5334/fce.121 Riffat J, Kutlu C, Tapia-Brito E, et al. Development and testing of a PCM enhanced domestic refrigerator with use of miniature DC compressor for weak/off grid locations. Int J Green Energy. 2022;19:1118-1131. doi: 10.1080/15435075.2021.1984244 10.1080/15435075.2021.1984244 Yusof YWM, Kassim M, Wan Shuhaimi WAA. Design and Analysis of Portable Solar Powered Refrigerator Unit’. In: 4th IEEE International Conference on Artificial Intelligence in Engineering and Technology, IICAIET; 2022. doi: 10.1109/IICAIET55139.2022.9936824 10.1109/IICAIET55139.2022.9936824 Abuelnour MA, Abuelnuor AAA, El-Kawi OSA. Design and analysis of a solar-powered refrigeration system with thermal energy storage for efficient storage of scorpion antivenom. Energy Storage. 2024;6:e622. doi: 10.1002/est2.622 10.1002/est2.622 Elarem R, Mellouli S, Abhilash E, Jemni A. Performance analysis of a household refrigerator integrating a PCM heat exchanger. Appl Therm Eng. 2017;125:1320-1333. doi: 10.1016/j.applthermaleng.2017.07.113 10.1016/j.applthermaleng.2017.07.113 Karthikeyan A, Aakhash Sivan V, Maher Khaliq A, Anderson A. Performance improvement of vapour compression refrigeration system using different phase changing materials. Mater Today Proc. 2021;44:3540-3543. doi: 10.1016/j.matpr.2020.09.296 10.1016/j.matpr.2020.09.296 Deshmukh MS, Deshmukh DS, Chavhan SP. A critical assessment of the implementation of phase change materials in the VCC of refrigerator. J Thermal Eng. 2022;8:562-572. doi: 10.18186/thermal.1149392 10.18186/thermal.1149392 Berdja M, Hamid A, Sari O. Characteristics and thickness effect of phase change material and frost on heat transfer and thermal performance of conventional refrigerator: Theoretical and experimental investigation. Int J Refrigerat. 2019;97:108-23. doi: 10.1016/j.ijrefrig.2018.10.003 10.1016/j.ijrefrig.2018.10.003 Cofré-Toledo J, Vasco DA, Isaza-Roldán CA, Tangarife JA. Evaluation of an integrated household refrigerator evaporator with two eutectic phase-change materials. Int J Refrigerat. 2018;93:29-37. doi: 10.1016/j.ijrefrig.2018.06.003 10.1016/j.ijrefrig.2018.06.003 Mastani Joybari M, Haghighat F, Moffat J, Sra P. Heat and cold storage using phase change materials in domestic refrigeration systems: The state-of-the-art review. Energy Build. 2015;106:111-124. doi: 10.1016/j.enbuild.2015.06.016 10.1016/j.enbuild.2015.06.016 Liu G, Li Q, Wu J, et al. ‘Improving system performance of the refrigeration unit using phase change material (PCM) for transport refrigerated vehicles: An experimental investigation in South China. J Energy Storage. 2022;51:104435. doi: 10.1016/j.est.2022.104435 10.1016/j.est.2022.104435 Pahamli Y, Valipour MS. Application of phase change materials in refrigerator and freezer appliances: A comprehensive review. J Heat Mass Transfer Res. 2021;8:87-104. doi: 10.22075/JHMTR.2021.21860.1316 10.22075/JHMTR.2021.21860.1316 Liu Z, Zhao D, Wang Q, Chi Y, Zhang L. Performance study on air-cooled household refrigerator with cold storage phase change materials. Int J Refrigerat. 2017;79:130-142. doi: 10.1016/j.ijrefrig.2017.04.009 10.1016/j.ijrefrig.2017.04.009 Purohit N, Dasgupta MS. Thermal storage material enhanced refrigerated display cabinet. Mater Today Proc. 2019;28:510-514. doi: 10.1016/j.matpr.2019.12.210 10.1016/j.matpr.2019.12.210 PCM Products Ltd. Eutectic Catalogue 2011. Cambridgeshire, United Kingdom: PCM Products Ltd.; 2011. Available: https://www.pcmproducts.net [Last accessed on 2024 Nov 01]. UK Government. Section 3: CCP Records, Health and Safety Executive; 2018. Available from: https://assets.publishing. service.gov.uk/media/5aec3202ed915d42f42b6286/hs_10.2.1_ section_3_ccp_records.pdf [Last accessed on 2025 Jan 07]. Mir S, Stevens R, Missen L, Okoloekwe A. Standard Operating Procedure: Fridge and Clinical Room Temperature Monitoring for Safe Storage of Medicine, Version 4. Senior Pharmacy Manager’s Group; 2015. Available from: https://www.elft. nhs.uk/sites/default/files/2024-09/sop_fridge_and_clinical_ room_temperature_monitoring_for_safe_storage_of_ medicine_6.0.docx [Last accessed on 2025 Jan 07]. Jarimi H, Zheng T, Zhang Y, et al. Solar photovoltaic- assisted DC vapour compression with a low-cost ice gel thermal battery for off-grid building cooling. J Build Eng. 2024;91:109350. doi: 10.1016/j.jobe.2024.109350 10.1016/j.jobe.2024.109350