Ensuring effective coastal protection requires not only attenuating incoming wave energy but also preserving the operational reliability of marine infrastructure. This study investigates the hydrodynamic behavior of two pontoon-type floating breakwaters—simple and stepped—through a combined program of new laboratory wave-flume experiments and high-fidelity numerical modeling in ANSYS AQWA. A 1:15 physical model was constructed and tested under regular waves with incident heights of 2.2–3.3 cm and periods of 0.44–0.84 s. The experiments showed that the simple pontoon achieved optimum energy dissipation at shorter wave periods (0.44 s), whereas the stepped configuration performed more efficiently in longer waves (0.84 s). Transmission coefficients (Kt) ranged from 0.2 to 1.5, with the stepped design consistently exhibiting stronger wave-energy reduction. Numerical simulations reproduced the laboratory findings with a maximum deviation of about 8%. To further enhance performance, an artificial-intelligence framework was developed that integrates artificial neural networks (ANNs) for rapid prediction of wave-induced loads, genetic algorithms (GAs) for multi-objective structural optimization, and reinforcement learning (RL) for adaptive real-time control. Together these methods lowered the mean transmission coefficient from 0.52 to 0.40 and improved computational efficiency by 88%. In addition, a prototype digital-twin environment, linked to an IoT sensor network, was established to enable continuous structural monitoring and to support condition-based maintenance. The results highlight the dominant influence of breakwater geometry, draft, and mooring characteristics on hydrodynamic behavior and demonstrate that AI-guided optimization provides a practical, scalable, and cost-effective pathway for designing resilient and low-carbon coastal infrastructure.
Keywords. Floating breakwaters; Coastal engineering; AI Optimization; Digital Twin; Experimental Validation
References
Akoz, M. S., Cobaner, M., Kirkgoz, M. S., & Oner, A. A. (2011). Prediction of geometrical properties of perfect breaking waves on composite breakwaters. Applied Ocean Research, 33(3), 178–185. https://doi.org/10.1016/j.apor.2011.03.003
Carraro, M., De Vanna, F., Zweiri, F., Benini, E., Heidari, A., & Hadavinia, H. (2022). CFD modeling of wind turbine blades with eroded leading edge. Fluids, 7(9), 302. https://doi.org/10.3390/fluids7090302
Castiglioni, I., Rundo, L., Codari, M., Di Leo, G., Salvatore, C., Interlenghi, M., Gallivanone, F., Cozzi, A., D’Amico, N. C., & Sardanelli, F. (2021). AI applications to medical images: From machine learning to deep learning. Physica Medica, 83, 9–24. https://doi.org/10.1016/j.ejmp.2021.02.006
Chen, X., Ma, D., & Liu, R. W. (2024). Application of artificial intelligence in maritime transportation. Journal of Marine Science and Engineering, 12(3), 439. https://doi.org/10.3390/jmse12030439
Cravero, C., De Domenico, D., & Marsano, D. (2023). The use of uncertainty quantification and numerical optimization to support the design and operation management of air-staging gas recirculation strategies in glass furnaces. Fluids, 8(2), 76. https://doi.org/10.3390/fluids8020076
Foteinis, S., Campbell, J. S., & Renforth, P. (2023). Life cycle assessment of coastal enhanced weathering for carbon dioxide removal from air. Environmental Science & Technology, 57(15), 6169–6178. https://doi.org/10.1021/acs.est.2c08633
Gesraha, M. R. (2006). Analysis of π-shaped floating breakwater in oblique waves: I. Impervious rigid wave boards. Applied Ocean Research, 28(5), 327–338. https://doi.org/10.1016/j.apor.2007.01.002
Guo, J., Wang, Y., & Cheng, Y. (2021). Hydrodynamic performance of a multi-module three-cylinder floating breakwater over reefs: Experimental investigation. Journal of Marine Science and Engineering, 9(12), 1364. https://doi.org/10.3390/jmse9121364
Hales, L. (1981). Floating breakwaters: State-of-the-art literature review. U.S. Army, Corps of Engineers, Coastal Engineering Research Center, Technical Report No. 81-1. https://apps.dtic.mil/sti/tr/pdf/A DA110692.pdf
Hasan, R., McPhillips, L., Warn, G., & Bilec, M. (2024). Life cycle assessment of green–grey coastal flood protection infrastructure: A case study from New Orleans. Environmental Research: Infrastructure and Sustainability, 4(2), 025001. https://doi.org/10.1088/2634-4505/ad3578
Isaacson, M., Baldwin, J., & Bhat, S. (1998). Wave propagation past a pile-restrained floating breakwater. International Journal of Offshore and Polar Engineering, 8(4), Article ISOPE-98-08-4-265. https://onepetro.org/IJOPE/article-abstract/27061/Wave-Propagation-Past-a-Pile-Restrained-Floating?redirec tedFrom=PDF
Issa-Zadeh, S. B., Esteban, M. D., López-Gutiérrez, J.-S., & Garay-Rondero, C. L. (2024). Unveiling the sensitivity analysis of port carbon footprint via power alternative scenarios: A deep dive into the Valencia Port case study. Journal of Marine Science and Engineering, 12(8), 1290. https://doi.org/10.3390/jmse12081290
Jimenez, V. J., Bouhmala, N., & Gausdal, A. H. (2020). Developing a predictive maintenance model for vessel machinery. Journal of Ocean Engineering and Science, 5(4), 358–386. https://doi.org/10.1016/j.joes.2020.03.003
Koutandos, E., Prinos, P., & Gironella, X. (2005). Floating breakwaters under regular and irregular wave forcing: Reflection and transmission characteristics. Journal of Hydraulic Research, 43(2), 174–188. https://doi.org/10.1080/00221686.2005.9641234
Kuntoji, G., Rao, M., & Rao, S. (2020). Prediction of wave transmission over submerged reef of tandem breakwater using PSO-SVM and PSO-ANN techniques. ISH Journal of Hydraulic Engineering, 26(3), 283–290. https://doi.org/10.1080/09715010.2018.1482796
Liang, J.-M., Liu, Y., Chen, Y.-K., & Li, A.-J. (2022). Experimental study on hydrodynamic characteristics of the box-type floating breakwater with different mooring configurations. Ocean Engineering, 254, 111296. https://doi.org/10.1016/j.oceaneng.2022.111296
Liu, Y., Li, H.-J., & Zhu, L. (2016). Bragg reflection of water waves by multiple submerged semi-circular breakwaters. Applied Ocean Research, 56, 67–78. https://doi.org/10.1016/j.apor.2016.01.008
Lyu, X., Trevelyan, J., & Subramanian, S. (2024). A symmetric experimental study of the interaction between waves and a novel symmetric-pontoon floating breakwater with hydrofoil attachments. Symmetry, 16(12), 1605. https://doi.org/10.3390/sym16121605
Peña, E., Ferreras, J., & Sanchez-Tembleque, F. (2011). Experimental study on wave transmission coef-ficient, mooring lines, and module connector forces with different designs of floating breakwaters. Ocean Engineering, 38(10), 1150–1160. https://doi.org/10.1016/j.oceaneng.2011.05.005
Qiao, Y., Yin, J., Wang, W., Duarte, F., Yang, J., & Ratti, C. (2023). Survey of deep learning for autonomous surface vehicles in marine environments. IEEE Transactions on Intelligent Transportation Systems, 24(4), 3678–3701. https://doi.org/10.1109/TITS.2023.3235911
Rijnsdorp, D. P., Vennell, R., & Almeida, L. P. (2021). Free infragravity waves in the North Sea. Journal of Geophysical Research: Oceans, 126(12), e2021JC017368. https://doi.org/10.1029/2021JC017368
Rutten, J., de Wit, F., van der Werf, J. J., & Ruessink, G. (2024). Continuous wave measurements collected in intermediate water depth in the North Sea during storm season 2021/2022. Data, 9(5), 70. https://doi.org/10.3390/data9050070
Sanitwong-Na-Ayutthaya, S., Saengsupavanich, C., Ariffin, E. H., Ratnayake, A. S., & Shin Yun, L. (2023). Environmental impacts of shore revetment. Heliyon, 9(9), e19646. https://doi.org/10.1016/j.heliyon.2023 .e19646
Samaei, S. R., Azarsina, F., & Ghahferokhi, M. A. (2016). Numerical simulation of floating pontoon breakwater with ansYS AQWA software and validation of the results with laboratory data. Bulletin de la Société Royale des Sciences de Liège, 85, Special Edition, 1487–1499. https://doi.org/10.25518/0037-9565.6194
Tsai, C.-M., Lai, Y.-H., Perng, J.-W., Tsui, I.-F., & Chung, Y.-J. (2019). Design and application of an autonomous surface vehicle with an AI-based sensing capability. 2019 IEEE Underwater Technology (UT), Kaohsiung, Taiwan, 1–4. https://doi.org/10.1109/UT.2019.8734350
Younes, R., & Lafon, P. (2009). Design optimization of floating breakwaters with an interdisciplinary fluid-solid structural problem. Canadian Journal of Civil Engineering, 36(11), 1732–1743. https://doi.org/10.1139/L09-112
Zhang, C., & Lu, Y. (2021). Study on artificial intelligence: The state of the art and future prospects. Journal of Industrial Information Integration, 23, 100224. https://doi.org/10.1016/j.jii.2021.100224
How to cite this article
Riffat, J., Samaei, S.R. and Ghahfarokhi, M.A. (2025). 'AI-Based Optimization and Hydrodynamic Performance of Floating Pontoon Breakwaters through Experimental and Numerical Modeling'. Global Decarbonisation, 1, pp. 1-26. https://doi.org/10.17184/eac.9847
Check for updates